CC3D Openpilot Open Source Flug Controller 32Bit Prozessor For Quadcopter Drone


 

23.99 Dólares USD

ROB-D120

Description:

The CC3D board is an all-in-one hardware that runs the stabilization OpenPilot firmware. It can be configured to monitor each cell of fly-wing flies on an octocopter and be monitored via the software OpenPilot Ground Control Station (GCS).
CopterControl from the OpenPilot project represents a new generation of multi-purpose aircraft stabilization platforms.
The CC3D has been designed from the ground up to the following features:
- A multi-rotor controller with AutoLevel, including TriCopters, QuadCopters and HexaCopters
- A flybarless helicopter controller with AutoLevel
- A Fixed Wing UAV controller
The CopterControl hardware has the following properties:
Powerful STM32 32-bit microcontroller run at 90MIPs with 128 KB Flash and 20KB RAM
3 axis high performance MEMS gyros and 3 axis high performance MEMS accelerometers
Tiny 36mmx36mm 4 layer PCB for superior electrical noise reduction and flight performance.
Software support for Windows, Mac and Linux
Direct high speed USB support no drivers required, a real plug & play device.
Spectrum satellite receiver support
Futaba S BUS hardware support
Innovative FlexiPort technology for maximum connection flexibility
4 MBits board EEPROM for configuration memory

Powerful STM32 32-bit microcontroller run at 90MIPs with 128 KB Flash and 20KB RAM
3 axis high performance MEMS gyros and 3 axis high performance MEMS accelerometers

None